cisco aironet 1600 user manual

9 Troubleshooting If you experience difficulty getting your access point installed and running, look for game fifa 2008 for pc a solution to your problem in this guide or in additional access point documentation.
Because weight and balance manual b737-200 the configuration process takes place on the controller, see the Cisco Wireless LAN Controller Configuration Guide for additional information.
Manufacturers Federal Communication Commission Declaration of Conformity Statement Tested To Comply With FCC Standards FOR home OR office USE Models Certification Numbers AIR-(L)AP1041N-A-K9 LDK102069 AIR-(L)AP1042N-A-K9 LDK102070 Manufacturer: Cisco Systems, Inc.
Note Access points mounted in a buildings environmental airspace must be powered using PoE to comply with safety regulations.
This guide also provides mounting instructions and limited troubleshooting procedures.Installation Summary Installing the access point involves these operations: Performing a pre-installation configuration (optional) Mounting the.The following basic settings must be config.After the access point finds the Cisco wireless LAN controller, it attempts to download the new operating system crack your back on acid code if the access point code version.You can view join-related information for the following numbers of access points: Up to 300 access points for 4400 series controllers, the Cisco WiSM, and the Catalyst 3750G Integrated Wireless LAN Controller Switch Up to three times the maximum number of access points supported.Locally stored controller IP address discoveryIf the access point was previously joined to a controller, the IP addresses of the primary, seco.The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points, which.2 1 About this Guide This Guide provides instructions on how to install and configure your Cisco Aironet 1040 Series Access Point.Figure 2 Pre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points Follow these steps to perform the pre-installation configuration.Table 1 shows the access point Status LED indications for various conditions.This section provides a brief synopsis of the configuration process.



Guidelines for Using Cisco Aironet Lightweight Access Points Keep these guidelines in mind when you use an 1040 series lig.
Click this URL to browse to complete access point mounting instructions: ml 8 Deploying the Access Point on the Wireless Network After you have mounted.
Check the connection between the access point and the Cisco wireless LAN controller and be sure that they are on the same subnet.This guide describes the dhcp method to convey the controller IP address.170 West Tasman Drive San Jose, CA USA.For detailed information, refer to the Configuring the Access Point for the First Time chapter of the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points for the Cisco IOS release you are using.This can be accomplished using dhcp, DNS, or IP subnet broadcast.Statement 332 Caution Do not use the supplied plastic wall anchors to mount the access point on a ceiling because.12 6 Additional Configuration for the Access Point in Autonomous Mode How you configure your access point depends on how you intend to use it in your wireless network.